Implementasi CUK Inverting Konverter Pada Battery Charging Terintegrasi Fotovoltaik Berbasis PID

Authors

  • Rahma Nur Amalia Politeknik Negeri Malang
  • Ika Noer Syamsiana Politeknik Negeri Malang
  • Lingga Ahadian Madani Politeknik Negeri Malang
  • Tri Warisaning Widhi Politeknik Negeri Malang

Keywords:

PWM, Voltage Sensor, Current Sensor, CUK Converter

Abstract

This study aims to test the performance of PWM, voltage sensors, ACS712 current sensors, and the efficiency of the inverting CUK converter in an energy conversion system. PWM testing showed a stable output frequency of 31.250 Hz across various duty cycles. Voltage sensor testing resulted in an average error of 1.2% for the solar panel sensor and 2.2% for the battery sensor, indicating good accuracy. ACS712 current sensor testing showed an average error of 1.5% at the solar panel input and 9.7% at the converter output to the battery. The inverting CUK converter achieved a maximum efficiency of 89% at a 14% duty cycle. These results indicate that the developed system has high accuracy and efficiency in power conversion. Paying attention to efficiency and accuracy will bring great benefits, such as cost efficiency, system stability, high energy quality. An important contribution of this research is to improve the efficiency and stability of renewable energy systems, especially those integrated with solar panels and batteries, and to support the development of more environmentally friendly and sustainable energy solutions.

References

Tim Sekretaris Jenderal Dewan Energi Nasional, “Indonesia Energy Out Look 2019,” J Chem Inf Model, vol. 53, no. 9, pp. 1689–1699, 2019.

B. K. Susanto, “Desain dan Implementasi Konverter Cuk Dengan Induktor Terkopel Untuk Reduksi Ripple Arus Masukan,” Institut Teknologi Sepuluh Nopember, 2017.

H. Suryoatmojo, A. P. Nandiwardhana, S. A. N. R. Arsya, H. P. Putra, R. Mardiyanto, and M. Ashari, “Comparisons of Cuk, SEPIC and Zeta converter performance for harmonics mitigation and PFC in BLDC speed control,” In Proceeding - 2016 International Seminar on Intelligent Technology and Its Application, ISITIA 2016, pp. 681–686, 2016, doi: 10.1109/ISITIA.2016.7828742.

A. Pradipta, D. C. Riawan, and S. Soedibyo, “Kontrol Aliran Daya Sistem Managemen Baterai Dengan Kontrol Droop Pada Sistem Pembangkit Hibrid PLTS-PLTB,” INSTITUT TEKNOLOGI SEPULUH NOPEMBER SURABAYA, 2018.

S. UTAMI, S. SAODAH, and A. PUDIN, “Penggunaan Algoritma Incremental Conductance pada MPPT dengan Buck Converter untuk Pengujian Indoor dan Outdoor,” ELKOMIKA: Jurnal Teknik Energi Elektrik, Teknik Telekomunikasi, & Teknik Elektronika, vol. 6, no. 1, p. 97, 2018, doi: 10.26760/elkomika.v6i1.97.

H. Suryoatmojo, A. P. Nandiwardhana, S. A. N. R. Arsya, H. P. Putra, R. Mardiyanto, and M. Ashari, “Comparisons of Cuk, SEPIC and Zeta converter performance for harmonics mitigation and PFC in BLDC speed control,” In Proceeding - 2016 International Seminar on Intelligent Technology and Its Application, ISITIA 2016, pp. 681–686, 2016, doi: 10.1109/ISITIA.2016.7828742.

V. Siva Prasad and D. Kumar Jena, “Improvement in Pre-Regulation for Power Factor Using CUK Converter,” International Journal of Research in Engineering and Science (IJRES) ISSN, vol. 3, no. 9, pp. 51–56, 2015, [Online]. Available: www.ijres.org

K. A. Mahafzah, A. Q. Al-Shetwi, M. A. Hannan, T. S. Babu, and N. Nwulu, “A New Cuk-Based DC-DC Converter with Improved Efficiency and Lower Rated Voltage of Coupling Capacitor,” Sustainability (Switzerland), vol. 15, no. 11, 2023, doi: 10.3390/su15118515.

H. Gholizadeh, S. A. Gorji, E. Afjei, and D. Sera, “Design and implementation of a new cuk-based step-up dc–dc converter,” Energies (Basel), vol. 14, no. 21, 2021, doi: 10.3390/en14216975.

R. P. Borase, D. K. Maghade, S. Y. Sondkar, and S. N. Pawar, “A review of PID control, tuning methods and applications,” 2021. doi: 10.1007/s40435-020-00665-4.

I. N. Syamsiana, R. N. A. Wijaya, A. D. W. Sumari, R. N. Amalia, and H. Sungkowo, “Maximization of battery charging efficiency in photovoltaic systems through PI Controlled SEPIC Converter with P&O MPPT,” Results in Engineering, vol. 26, no. May, p. 105469, 2025, doi: 10.1016/j.rineng.2025.105469.

C. M. Coman, A. Florescu, and C. D. Oancea, “Improving the efficiency and sustainability of power systems using distributed power factor correction methods,” Sustainability (Switzerland), vol. 12, no. 8, 2020, doi: 10.3390/SU12083134.

Rahma Nur Amalia, Ika Noer Syamsiana, Aditya Andri Prasojo, and Ahmad Romi Alfa Hidayah Fauzi, “Desain dan Implementasi Battery Charging pada Fotovoltaik dengan Topologi Non-Inverting Cuk Konverter,” Jurnal Elektronika dan Otomasi Industri, vol. 12, no. 1, pp. 19–32, 2025, doi: 10.33795/elkolind.v12i1.7370.

T. Berliana et al., “Analisis Perbandingan Efisiensi Buck-Boost Converter Dengan Cuk Converter Pada Panel Surya,” KOLONI: Jurnal Multidisiplin Ilmu, vol. 3, no. 2, pp. 2828–6863, 2024.

D. Sevim and V. Gider, “Designing a Control Interface and PID Controller of CUK Converter,” vol. 11, no. 1, p. 2021, 2021, [Online]. Available: https://dergipark.org.tr/en/pub/ejtEuropeanJournalofTechniquejournalhomepage:https://dergipark.org.tr/en/pub/

R. N. Amalia and Wijaya Kusuma, “Desain Simulasi dan Analisa Closed Loop Boost Converter Terintegrasi Solar PV Berbasis PID,” Elposys: Jurnal Sistem Kelistrikan, vol. 10, no. 1, 2023, doi: 10.33795/elposys.v10i1.1078.

Downloads

Published

2025-06-30

How to Cite

Amalia, R. N., Syamsiana, I. N., Madani, L. A., & Widhi, T. W. (2025). Implementasi CUK Inverting Konverter Pada Battery Charging Terintegrasi Fotovoltaik Berbasis PID. Elposys: Jurnal Sistem Kelistrikan, 12(2), 73–78. Retrieved from https://jurnal.polinema.ac.id/index.php/elposys/article/view/7286